On the other part of the enclosure, install the Single Board Computer with the M3 screws. Please remove the plastic from the bottom of SBC before you paste. Fix it with 4 screws (14cm)
Install the DDR4 SODIMM, the MSATA SSD and the PCI Express adaptor board.
Set the jumpers on the SBC.
Please put the enclosure with SBC and the other side on the same plane like the figure shown. Connect the power cable to the SBC.
Warning: If the power cable is plugged in the wrong order or to the wrong port you will break the PCB !
Connect the power cable in a PTSM connector and plug this connector in the SDR main board.
Connect the ribbon FFC between the PCI Express adaptor board and the SDR main board.
Connect the second RJ45 cable between the SBC and the SDR main board.
Before closing the ORS, you can blow some compressed air on the PCB to make sure there are no metal dust on it. Also write down the PC serial number. Close the enclosure and connect the PoE cable to start the system.