Take out the waterproof RJ45 connector
Prepare Waterproof Cable Mount Connector
Prepare the waterproof cable mount connector from your ORS package and a shielded Ethernet cable.
Waterproof Cable Mount Connector
Split the connector to 4 parts. Note that C is inside of B.
Cut rubber ring C
Please have C cut as shown in the picture.
Note: cutting rubber ring C is in order to pass the Ethernet cable through. Instead of doing this, you can also make your Ethernet cable so the cable itself can go through the rubber without the RJ45 connector.
Pass the cable
Pass the shielded Ethernet cable through D C B A in order.
Connect parts
Connecting each part tightly as original.
Tighten the connector
Turn tight D so that there is no gap between shielded Ethernet cable and rubber ring C.
Place warning labels on the POE connectors
Please put the following label before packaging the ORS:
- "WARNING: DO NOT UNPLUG POE BEFORE POWER" on the POE cable next to the waterproof connector:
- Template to use for Dymo Label printer: 10 spaces + Warning: DO NOT UNPLUG POE BEFORE POWER
- Print a first label, put it on the cable by wrapping the empty spaces around the cable, then print another label and put it on the back of the first label
Plug SIM Card Reader to your laptop and insert SIM
Flash the SIM Card
Execute this command:
user@laptop:~# ./write-sim-card --ors-reference ORSXXX
Once the first SIM card is plugged, press the Enter key
Wait until all the transfer is done, then put the next sim card, and press Enter key again. Do this for all 5 SIM cards.
Put the 5 SIM Cards in the SIM Card holder
Put a label on the SIM Card box
Gather the rest of the accessories
In total you will need:
- 1 5M POE RJ45 Cable with the waterproof connectors installed
- 1 ORS mount kit (make sure the 4 screws are there)
- 1 ORS handle (it should be already screwed on the ORS)
- 1 SIM Card box with 5 SIM Cards + 1 SIM PIN
- 2 N-type stick Antennas
- 2 N-to-SMA RF adaptors
- 1 POE adaptor